World Library  
Flag as Inappropriate
Email this Article

Internet Key Exchange

Article Id: WHEBN0000194340
Reproduction Date:

Title: Internet Key Exchange  
Author: World Heritage Encyclopedia
Language: English
Subject: Internet Security Association and Key Management Protocol, IPsec, Security association, Ike, Rekeying
Collection: Cryptographic Protocols, Ipsec
Publisher: World Heritage Encyclopedia

Internet Key Exchange

In computing, Internet Key Exchange (IKE or IKEv2) is the protocol used to set up a security association (SA) in the IPsec protocol suite. IKE builds upon the Oakley protocol and ISAKMP.[1] IKE uses X.509 certificates for authentication - either pre-shared or distributed using DNS (preferably with DNSSEC) and a Diffie–Hellman key exchange - to set up a shared session secret from which cryptographic keys are derived.[2][3] In addition, a security policy for every peer which will connect must be manually maintained.[2]


  • History 1
  • Architecture 2
    • IKEv1 phases 2.1
    • Problems with IKE 2.2
    • Improvements with IKEv2 2.3
  • Protocol extensions 3
  • Implementations 4
  • Vulnerabilities 5
  • See also 6
  • References 7
  • External links 8


The Internet Engineering Task Force (IETF) originally defined IKE in November 1998 in a series of publications (Request for Comments) known as RFC 2407, RFC 2408 and RFC 2409:

  • RFC 2407 defined The Internet IP Security Domain of Interpretation for ISAKMP.[4]
  • RFC 2408 Internet Security Association and Key Management Protocol (ISAKMP) [5]
  • RFC 2409 defined The Internet Key Exchange (IKE) [6]

IKE was updated to version two (IKEv2) in December 2005 by RFC 4306.[7] Some open details were clarified in October 2006 by RFC 4718.[8] These two documents plus additional clarifications were combined into the updated IKEv2 RFC 5996[9] which was published in September 2010. A later update upgraded the document from Proposed Standard to Internet Standard, and was published as RFC 7296 in October 2014.

The parent organization of the IETF, The Internet Society (ISOC), has maintained the copyrights of these standards as freely available to the Internet community.


Most IPsec implementations consist of an IKE daemon that runs in user space and an IPsec stack in the kernel that processes the actual IP packets.

User-space daemons have easy access to mass storage containing configuration information, such as the IPsec endpoint addresses, keys and certificates, as required. Kernel modules, on the other hand, can process packets efficiently and with minimum overhead—which is important for performance reasons.

The IKE protocol uses UDP packets, usually on port 500, and generally requires 4–6 packets with 2–3 turn-around times to create an SA on both sides. The negotiated key material is then given to the IPsec stack. For instance, this could be an AES key, information identifying the IP endpoints and ports that are to be protected, as well as what type of IPsec tunnel has been created. The IPsec stack, in turn, intercepts the relevant IP packets if and where appropriate and performs encryption/decryption as required. Implementations vary on how the interception of the packets is done—for example, some use virtual devices, others take a slice out of the firewall, etc.

IKEv1 consists of two phases: phase 1 and phase 2.[10]

IKEv1 phases

IKE phase one's purpose is to establish a secure authenticated communication channel by using the Diffie–Hellman key exchange algorithm to generate a shared secret key to encrypt further IKE communications. This negotiation results in one single bi-directional ISAKMP Security Association (SA).[11] The authentication can be performed using either pre-shared key (shared secret), signatures, or public key encryption.[12] Phase 1 operates in either Main Mode or Aggressive Mode. Main Mode protects the identity of the peers; Aggressive Mode does not.[10]

During IKE phase two, the IKE peers use the secure channel established in Phase 1 to negotiate Security Associations on behalf of other services like IPsec. The negotiation results in a minimum of two unidirectional security associations (one inbound and one outbound).[13] Phase 2 operates only in Quick Mode.[10]

Problems with IKE

Originally, IKE had numerous configuration options but lacked a general facility for automatic negotiation of a well-known default case that is universally implemented. Consequently, both sides of an IKE had to exactly agree on the type of security association they wanted to create — option by option — or a connection could not be established. Further complications arose from the fact that in many implementations the debug output was difficult to interpret, if there was any debug routine at all.

The IKE specifications were open to a significant degree of interpretation, bordering on design faults (Dead-Peer-Detection being a case in point), giving rise to different IKE implementations not being able to create an agreed-upon security association at all for many combinations of options, however correctly configured they might appear at either end.

Improvements with IKEv2

The need and intent of an overhaul of the IKE protocol was described in Appendix A of RFC 4306. The following issues were addressed:

  • Fewer RFCs: The specifications for IKE were covered in at least three RFCs, more if one takes into account NAT traversal and other extensions that are in common use. IKEv2 combines these in one RFC as well as making improvements to support for NAT traversal and firewall traversal in general.
  • Standard Mobility support: There is a standard extension for IKEv2 (named MOBIKE) used to support mobility and multihoming for it and ESP. By use of this extension IKEv2 and IPsec can be used by mobile and multihomed users.
  • NAT traversal: The encapsulation of IKE and ESP in UDP port 4500 enables these protocols to pass through a device or firewall performing NAT.[14]
  • Simple message exchange: IKEv2 has one four-message initial exchange mechanism where IKE provided eight distinctly different initial exchange mechanisms, each one of which had slight advantages and disadvantages.
  • Fewer cryptographic mechanisms: IKEv2 uses cryptographic mechanisms to protect its packets that are very similar to what IPsec Encapsulating Security Payload (ESP) uses to protect the IPsec packets. This led to simpler implementations and certifications for Common Criteria and FIPS 140-2, which require each cryptographic implementation to be separately validated.
  • Reliability and State management: IKEv2 uses sequence numbers and acknowledgments to provide reliability and mandates some error processing logistics and shared state management. IKE could end up in a dead state due to the lack of such reliability measures, where both parties were expecting the other to initiate an action - which never eventuated. Work arounds (such as Dead-Peer-Detection) were developed but not standardized. This meant that different implementations of work-arounds were not always compatible.
  • Denial of Service (DoS) attack resilience: IKEv2 does not perform much processing until it determines if the requester actually exists. This addressed some of the DoS problems suffered by IKE which would perform a lot of expensive cryptographic processing from spoofed locations.

This can be explained like this:

Suppose HostA has a Security Parameter Index (SPI) A and HostB has an SPI B.

The scenario is like this:


If HostB is experiencing large amount of half-open IKE init connection, the responder will send an unencrypted reply message of the ike_sa_init with a notify message of type cookie and the responder will expect an ike_sa_init request with that cookie value in a notify payload. This is to ensure that the initiator is really capable of handling a response from the responder.


Protocol extensions

The IETF ipsecme working group has standardized a number of extensions, with the goal of modernizing the IKEv2 protocol and adapting it better to high volume, production environments. These extensions include:

  • IKE session resumption: the ability to resume a failed IKE/IPsec "session" after a failure, without the need to go through the entire IKE setup process (RFC 5723).
  • IKE redirect: redirection of incoming IKE requests, allowing for simple load-balancing between multiple IKE endpoints (RFC 5685).
  • IPsec traffic visibility: special tagging of ESP packets that are authenticated but not encrypted, with the goal of making it easier for middleboxes (such as intrusion detection systems) to analyze the flow (RFC 5840).
  • Mutual EAP authentication: support for EAP-only (i.e., certificate-less) authentication of both of the IKE peers; the goal is to allow for modern password-based authentication methods to be used (RFC 5998).
  • Quick crash detection: minimizing the time until an IKE peer detects that its opposite peer has crashed (RFC 6290).
  • High availability extensions: improving IKE/IPsec-level protocol synchronization between a cluster of IPsec endpoints and a peer, to reduce the probability of dropped connections after a failover event (RFC 6311).


IKE is supported as part of the IPsec implementation in Windows 2000, Windows XP, Windows Server 2003, Windows Vista and Windows Server 2008.[15] The ISAKMP/IKE implementation was jointly developed by Cisco and Microsoft.[16]

Microsoft Windows 7 and Windows Server 2008 R2 partially support IKEv2 (RFC 4306) as well as MOBIKE (RFC 4555) through the VPN Reconnect feature (also known as Agile VPN).

There are several open source implementations of IPsec with associated IKE capabilities. On Linux, Openswan and strongSwan implementations provide an IKE daemon called pluto, which can configure (i.e., establish SAs) to the KLIPS or NETKEY kernel-based IPsec stacks. NETKEY is the Linux 2.6 kernel's native IPsec implementation.

The Berkeley Software Distributions also have an IPsec implementation and IKE daemon, and most importantly a cryptographic framework (OpenBSD Cryptographic Framework, OCF), which makes supporting cryptographic accelerators much easier. OCF has recently been ported to Linux.

A significant number of network equipment vendors have created their own IKE daemons (and IPsec implementations), or license a stack from one another.

There are a number of implementations of IKEv2 and some of the companies dealing in IPsec certification and interoperability testing are starting to hold workshops for testing as well as updated certification requirements to deal with IKEv2 testing. ICSA Labs held its latest IKEv2 Interoperability Workshop in Orlando, FL in March 2007 with 13 vendors from around the world.

The following open source implementations of IKEv2 are currently available:


Leaked NSA presentations released by Der Spiegel indicate that IKE is being exploited in an unknown manner to decrypt IPSec traffic, as is ISAKMP.[17]

See also


  1. ^ The Internet Key Exchange (IKE), RFC 2409, §1 Abstract
  2. ^ a b RFC 3129: Requirements for Kerberized Internet Negotiation of Keys,  
  3. ^ RFC 4322: Opportunistic Encryption using the Internet Key Exchange (IKE),  
  4. ^ "RFC 2407 The Internet IP Security Domain of Interpretation for ISAKMP". Internet Engineering Task Force (IETF). 
  5. ^ "RFC 2408 Internet Security Association and Key Management Protocol (ISAKMP)". Internet Engineering Task Force (IETF). 
  6. ^ D. Harkins. "RFC 2409 The Internet Key Exchange (IKE)". Internet Engineering Task Force (IETF). 
  7. ^ C. Kaufman (Microsoft) (December 2005). "RFC 4306 Internet Key Exchange (IKEv2) Protocol". Internet Engineering Task Force (IETF). 
  8. ^ P. Eronen (Nokia), P. Hoffman (VPN Consortium) (October 2006). "RFC 4718 IKEv2 Clarifications and Implementation Guidelines". Internet Engineering Task Force (IETF). 
  9. ^ C. Kaufman (Microsoft), P. Hoffman (VPN Consortium), Y. Nir (Check Point), P. Eronen (Independent) (September 2010). "RFC 5996 Internet Key Exchange (IKEv2) Protocol". Internet Engineering Task Force (IETF). 
  10. ^ a b c "RFC 2409 The Internet Key Exchange (IKE)", Internet Engineering Task Force (IETF), p. 5
  11. ^ "RFC 2409 The Internet Key Exchange (IKE)", Internet Engineering Task Force (IETF), p. 6
  12. ^ "RFC 2409 The Internet Key Exchange (IKE)", Internet Engineering Task Force (IETF), p. 10-16
  13. ^ "RFC 4306 Internet Key Exchange (IKEv2) Protocol", Internet Engineering Task Force (IETF), p. 11,33
  14. ^ "RFC 4306: Internet Key Exchange (IKEv2) Protocol", Internet Engineering Task Force (IETF), p 38-40
  15. ^ Internet Key Exchange: Internet Protocol Security (IPsec): Technet
  16. ^ Using IPSec in Windows 2000 and XP, Part 1
  17. ^ Fielded Capability: End-to-end VPN SPIN9 Design Review (PDF), NSA via 'Der Spiegel', p. 5 

External links

  • RFC 2407 The Internet IP Security Domain of Interpretation for ISAKMP, Internet Engineering Task Force (IETF)
  • RFC 2408 Internet Security Association and Key Management Protocol (ISAKMP), Internet Engineering Task Force (IETF)
  • RFC 2409 The Internet Key Exchange (IKE), Internet Engineering Task Force (IETF)
  • RFC 7296: Internet Key Exchange Protocol Version 2 (IKEv2), Internet Engineering Task Force (IETF)
  • Overview of IKE (from Cisco)
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.

Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.