World Library  
Flag as Inappropriate
Email this Article

Rigid needle adapter

Article Id: WHEBN0012116884
Reproduction Date:

Title: Rigid needle adapter  
Author: World Heritage Encyclopedia
Language: English
Subject: Printed circuit board
Collection:
Publisher: World Heritage Encyclopedia
Publication
Date:
 

Rigid needle adapter

Function mode of a rigid needle adapter

The concept of the rigid needle adapter makes possible a contacting of finest structures on printed and assembled circuit board and also direct contacting in fine-pole connectors. For this concept one need every time a raster head and a rigid needle adapter. The spring probes are arranged in a compact grid in the raster head so that up to 280 spring probes per square cm can be integrated. The rigid needles are moved to the desired contact point by the spring probes in the rigid needle adapter. Contacting pitch down to 150 µm can be tested by the movement of the rigid needles.

The contacting stroke is effected in the needle adapter. Contacting forces of 0.4 N to 1.5 N depending on the spring probe are exerted on the contacting point by the spring excursion of approximately 2.5 mm.

Life cycle of rigid needle adapters

The contacting tip of the rigid needle becomes blunt in time through contacting. The service life thus depends mainly on the material to be contacted. Under optimum conditions up to 500,000 contactings and more can be achieved with the rigid needles. Spring pins manufactured specifically for this application and the compact design mean that service lives of far more than 1 million contact cycles are possible in practice.

Combination of spring probes and rigid needles

Combination of spring probes and rigid needles

The rigid needle adapter is manufactured to customer requirements. Rigid needle adapters for very fine structures are also called MCA (Micro Contacting Adapter). The feasibility matrix shows which spring pins can be combined with which rigid needles. The concept allows not only the contacting of assembled and bare printed circuit boards (PCBs) but also the direct contacting of high-pole micro-connectors.

Possible constant current (IC) and pulsed current (IP) at 10 ms:

  • A: IC=0.3 A / IP=0.9 A
  • B: IC=0.6 A / IP=1.8 A
  • C: IC=1.0 A / IP=3.0 A
  • D: IC=2.0 A / IP=6.0 A
  • E: IC=3.0 A / IP=9.0 A

References

External links

  • Manufacturer of rigid needle adapter (fine-pitch): Microcontact AG
  • Manufacturer of rigid needle adapter: ATX
  • Manufacturer of spring probes: Ingun
  • Manufacturer of spring probes: Feinmetall
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 


Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.