World Library  
Flag as Inappropriate
Email this Article

Burst noise

Article Id: WHEBN0001903997
Reproduction Date:

Title: Burst noise  
Author: World Heritage Encyclopedia
Language: English
Subject: Noise, Shot noise, Burst, Popcorn (disambiguation), List of noise topics
Collection: Noise
Publisher: World Heritage Encyclopedia
Publication
Date:
 

Burst noise

Graph of burst noise

Burst noise is a type of electronic noise that occurs in semiconductors. It is also called popcorn noise, impulse noise, bi-stable noise, or random telegraph signal (RTS) noise.

It consists of sudden step-like transitions between two or more discrete voltage or current levels, as high as several hundred microvolts, at random and unpredictable times. Each shift in offset voltage or current often lasts from several milliseconds to seconds, and sounds like popcorn popping if hooked up to an audio speaker.[1]

Popcorn noise was first observed in early point contact diodes, then re-discovered during the commercialization of one of the first semiconductor op-amps; the 709.[2] No single source of popcorn noise is theorized to explain all occurrences, however the most commonly invoked cause is the random trapping and release of charge carriers at thin film interfaces or at defect sites in bulk semiconductor crystal. In cases where these charges have a significant impact on transistor performance (such as under an MOS gate or in a bipolar base region), the output signal can be substantial. These defects can be caused by manufacturing processes, such as heavy ion implantation, or by unintentional side-effects such as surface contamination.[3][4]

Individual op-amps can be screened for popcorn noise with peak detector circuits, to minimize the amount of noise in a specific application.[5]

See also

References

  1. ^ Random Telegraph Signal — Review of Noise in Semiconductor Devices and Modeling of Noise in Surrounding Gate MOSFET, Bipin Rajendran
  2. ^ Operational Amplifier Noise Prediction — Intersil Application Note
  3. ^ Noise Analysis In Operational Amplifier Circuits — Texas Instruments application report
  4. ^ Noise Sources in Bulk CMOS — Kent H. Lundberg
  5. ^ Op-Amp Noise can be Deafening Too "Today, although popcorn noise can still occasionally occur during manufacturing, the phenomenon is sufficiently well understood that affected devices are detected and scrapped during test."

External links

  • A review of popcorn noise and smart filtering, www.advsolned.com
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 


Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.