World Library  
Flag as Inappropriate
Email this Article

Carro Armato P 40

Carro Armato P 26/40
P26/40 medium tank in Fiat-Ansaldo factory.
Type Medium tank
Place of origin Italy
Service history
Used by Nazi Germany
Wars World War II
Production history
Designed 1940
Manufacturer Ansaldo
Produced 1943-1944
Number built 103
Weight 26 tonnes
Length 5.80 m (19 ft 0 in)
Width 2.80 m (9 ft 2 in)
Height 2.5 m (8 ft 2 in)
Crew 4 (commander/gunner, loader, driver, radio-operator)

Armour Turret: front 60 mm (2.4 in), sides and rear 45 mm (1.8 in), top 20 mm (0.8 in)
Hull: front 50 mm (2.0 in), sides 45 mm (1.8 in) and rear 40 mm (1.6 in), bottom 14 mm (0.6 in)
Ansaldo 75 mm L/34 gun
1-2 × 8 mm Breda 38 machine guns
Engine V-12 SPA 342 diesel, 24 litre
330 hp (243 kW)[1]
Power/weight 11.53 hp/tonne
Suspension Semi-elliptical leaf spring bogies
280 km (170 mi)
Speed 40 km/h (25 mph) road
25 km/h (16 mph) off-road

The P 26/40 was an Italian World War II medium tank. It was armed with a 75 mm gun and an 8 mm Breda machine gun, plus another optional machine gun in an anti-aircraft mount. The official Italian designation was Carro Armato ("armoured vehicle") P 26/40.

The designation means: P for pesante (Italian: "heavy"), the weight of 26 tonnes, and the year of adoption: 1940.[2] Though physically a medium tank in size, weight, armor, and armament, it was classified as a heavy tank by the Italian military in reflection of its intended support of smaller tanks on the battlefield.

Design had started in 1940 but very few had been built by the time Italy signed the armistice with the Allies in September 1943 and the few produced afterwards were used by the Germans.


  • History 1
  • Design 2
  • Production 3
  • Variants 4
  • Surviving vehicles 5
  • See also 6
    • Tanks of comparable role, performance, and era 6.1
  • Notes 7
  • References 8


The development work began in 1940, on Benito Mussolini's specific orders.[3] Initial requirements were for a 20 tonne (the maximum load allowed by pontoon bridges) tank with a 47 mm gun, three machine-guns and a crew of five, but this was quickly superseded by another 25 tonne design, to be named P26. The development work proceeded quickly except for the engine; the Italian military staff, the Stato Maggiore, wanted a diesel power-plant, while the builders favoured a petrol engine.

However, in Italy at the time there were no engines (diesel or petrol) available capable of developing the 300 hp (220 kW) required, and the Italian tank industry (i.e. the duopoly Fiat-Ansaldo) did not turn to easily available aircraft engines for its tanks as the contemporary U.S. and British tank manufacturers had done. The design of a new engine was very slow and in the end a 420 hp (310 kW) petrol engine was eventually tested.

Provisionally called P75 (from the gun's calibre), the first design (whose prototype was ready on mid-1941) was similar to an enlarged Fiat M13/40, but with a 75/18 howitzer (the same fitted on the Semovente da 75/18) and more armour; the prototype was then modified by replacing the main gun with a 75/32 gun with a co-axial machine-gun. After learning about Soviet T-34s in 1941, thanks to a captured tank supplied by the Germans, the whole design was radically modified: the armour was quickly thickened (from 40 to 50 mm on the front and from 30 to 40 mm on the sides) and re-designed, adopting more markedly sloped plates, and the new 75/34 gun was adopted; meanwhile the dual barbette mount in the hull was deleted.[4] The gun designation "75/34" referred to a 75 mm bore diameter gun with a length equal to 34 calibres. However, the weight increase (which now topped at 26 tonne) and the difficulties in finding a suitable engine further hampered the start of mass production; in the end, it was decided that the prototype and the early production samples were to be equipped with a 330 HP SPA 8V diesel engine, later to be replaced by a 420 HP petrol engine.

By the armistice, only a few (between one and five depending on the source) pre-production models were completed before the Italian Armistice in September 1943, at which point they were taken over by the German Wehrmacht. A few were used in combat, under the German designation of Panzerkampfwagen P40 737(i), for example at Anzio; some, without engines, were used as static strongpoints.


The turret was operated by two crew members and this was a significant drawback as it put excessive workload on the tank's commander. At that time, most new tanks were designed with three-man turrets. Moreover, it lacked a commander's cupola.

The main weapon was the 75/34 gun, a development of the Model 37 divisional gun (34 calibres long), retaining the same dimensions. This weapon had a muzzle velocity of around 700 m/s (2,300 ft/s); and was normally provided with around 75 rounds of ammunition. Its armour-piercing shells could penetrate roughly 70 mm of armour at 500 meters.[5] For secondary armament, the P 40 had a co-axial machine-gun and another which could be used in the anti-aircraft role, eschewing the traditional dual mount in the hull; the standard ammunition load was also lower, only around 600 rounds, compared to 3,000 of the "M" series.

The mechanical systems were a development of the "M" series, in particular the leaf spring suspension which was reliable, but in rough terrain would not allow speeds similar to the more modern Christie suspension or torsion bar suspension. Nevertheless, the good power-to-weight ratio represented a significant improvement in mobility over its predecessors.

A P40 being presented to Adolf Hitler alongside a wooden Jagdtiger mockup in East Prussia, 20 October 1943.

The armour, quite resistant by Italian standards, was sloped and 60 mm thick at the turret front and mantlet (by comparison the M13/40 had 42 mm), but it was still riveted at a time when most tanks were constructed by welding. Compared to welded armour, riveted armour is vulnerable to breaking apart at the joints meaning that even quite resistant plates can be defeated by rivet failures. The front armour had a compound slope with a best facing of 50 mm/45 degrees.

The armour was capable of protecting the tank against early anti-tank guns such as the British QF 2 pounder (40 mm, 1.6 in), but was vulnerable to subsequent anti-tank weapons such as the British QF 6 pounder (57 mm, 2.24 in) that entered service in 1942 and the QF 17 pounder (76 mm, 3 in) coming into use in 1943.

The P 40 design was reasonably up-to-date, but the tank was without some modern features such as welded armour, modern suspension, and a cupola for the commander. The P 40 was designated as a heavy tank in Italy, not because of its weight, but because of its intended role[6] in support of the widely used medium ("M") tanks on the battlefields. In weight, armour and armament it was similar to the medium tanks of the Wehrmacht or other contemporary armies, its armament and protection being roughly the same as the early production American M4 Sherman tank.[7] It was the final evolution of Italian tank designs, that began with the Vickers-based tankettes (such as the CV29 and L3/35) and developed into models such as the M11/39 medium tank, a much heavier construction whose internal design shared many characteristics of the earlier tankettes.


Some 1,200 tanks were ordered (but the total was later reduced to 500 when development work on the heavier P 43 began), but the start of production was delayed by the engine problems and by other factors, such as the bombing of the SPA factory in Turin in September 1942; in the end, production began only in summer 1943. About a hundred P 40s were built by Ansaldo from then until the end of the war, although most were not entirely completed because of a lack of engines.


There were at least two planned variants of the P 40, developed from early 1943 when the Italian Army realized that the tank was inferior to other designs such as the German Panther. The first one was named P 43, a tank with a weight of some 30 tonnes, with armour plates some 50–80 mm thick and a main armament of either the 75/34 gun or a 105/23 gun. In September 1943 Fiat and Ansaldo began development of a new design which could be comparable to the Panther, and the result was the P 43 bis, with heavily sloped armour, a 450 HP engine and a 90/42 gun. These designs never passed the wooden mock-up stage.[8]

The other project was the Semovente 149/40, based on the P 40 hull. Only one of these vehicles was ever built. It was intended to be a highly mobile self-propelled gun, and its armament was the most powerful gun of the Royal Italian Army: a 149 mm / 40 calibre artillery piece with a range of over 23 km (14 mi) (slightly more than that of the US 155 mm M1 Long Tom). This gun was produced in very few numbers, and the Italian artillery remained equipped mainly with obsolete weapons for the duration of the war. Due to its mass, it was quite bulky to move, and so it was decided to build a self-propelled version, utilizing the most powerful of all Italian military vehicles. All space of the P 40 hull was dedicated to supporting the gun, so the ammunition and crew would have required additional vehicles to be moved. The gun would have been ready to fire in three minutes from coming to a stop, compared to the 17 minutes required by towed artillery.

Work on the Semovente 149/40 started in 1942 and the prototype was tested in 1943, but the Italian Army was not very impressed. After the Armistice the vehicle was acquired by the Germans, and they weren't impressed by it either. Finally American forces captured it during the invasion of Germany and sent it to the Aberdeen Proving Ground for testing.

Surviving vehicles

Two P26/40s are believed to exist, one preserved at the Museo della Motorizzazione in Rome and another reportedly kept near the army barracks near Lecce in the 1990s, although its current fate is unknown.[9][10]

See also

Tanks of comparable role, performance, and era


  1. ^ Cappellano, F; Battistelli, P P (2012). Italian Medium Tanks. UK: Osprey. p. 48.  
  2. ^ Cappellano, F; Battistelli, P P (2012). Italian medium tanks : 1939-45. Oxford: Osprey Publ. pp. 5, 17.  
  3. ^ Cappellano, F; Battistelli, P P (2012). Italian medium tanks : 1939-45. Oxford: Osprey Publishing. p. 17.  
  4. ^ Cappellano, F; Battistelli, P P (2012). Italian medium tanks : 1939-45. Oxford: Osprey Publishing. pp. 17–18.  
  5. ^ Cappellano, F; Battistelli, P P (2012). Italian medium tanks : 1939-45. Oxford: Osprey Publishing. p. 35.  
  6. ^
  7. ^ Cappellano, Filippo (February 2013). "L'esercito italiano nel 1943". Storia Militare Dossier (6): 207. 
  8. ^ Cappellano, F; Battistelli, P P (2012). Italian Medium Tanks : 1939-45. Oxford: Osprey. p. 18.  
  9. ^ "Carro Armato P40 Tank". Preserved Tanks .com. Retrieved 25 April 2015. 
  10. ^ "CENSIMENTO DEI VEICOLI CORAZZATI STORICI IN ITALIA". Ferrea Mole (in Italian). Retrieved 25 April 2015. 


  • C. Falessi and B. Pafi, "Il carro armato P. 40", Storia Illustrata #150, May 1970.
  • Pignato, Nicola, Storia dei mezzi corazzati, Fratelli Fabbri Editore, 1976, volume 2
  • Sgarlato, Nico, I corazzati italiani, an illustrated monograph on Italian tanks and self-propelled guns, April 2006.
  • F Cappellano & P P Battistelli (2012). Italian Medium Tanks (New Vanguard No. 195) UK: Osprey Publishing. ISBN 9781849087759.
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.

Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.