World Library  
Flag as Inappropriate
Email this Article

Centaur (rocket)

 

Centaur (rocket)

Centaur

Centaur-2A upper stage of an Atlas IIA
Manufacturer Boeing IDS
United Launch Alliance
Country of origin United States
Used on Atlas-Centaur
Atlas G
Atlas I
Atlas II
Atlas III
Atlas V
Titan IIIE
Titan IV(401)A/B
Saturn I (unflown)
Space Shuttle (unflown)
Associated stages
Derivatives ACES
Launch history
Status Active
Total launches 200
Maiden flight 9 May 1962

Centaur is a rocket stage designed for use as the upper stage of space launch vehicles. Centaur boosts its satellite payload to geosynchronous orbit or, in the case of an interplanetary space probe, to or near to escape velocity. Centaur was the world's first high-energy upper stage, burning liquid hydrogen (LH2) and liquid oxygen (LOX).

Centaur, named after the centaurs of Greek mythology, was the brainchild of Karel J. "Charlie" Bossart (the man behind the Atlas ICBM) and Dr. Krafft A. Ehricke, both Convair employees.[1] Their design was essentially a smaller version of the Atlas, with its concept of using lightweight "stainless steel balloon" tanks whose structural rigidity was provided solely by the pressure of the propellants within. To keep the tanks from collapsing prior to propellant loading, they were either kept in "stretch" or pressurized with nitrogen gas.

Centaur uses a common double-bulkhead to separate the LOX and LH2 tanks. The two stainless steel skins are separated by a 0.25 inch (6.4 mm) layer of fiberglass honeycomb. The extreme cold of the LH2 on one side creates a vacuum within the fiberglass layer, giving the bulkhead a low thermal conductivity, and thus preventing heat transfer from the relatively warm LOX to the super cold LH2. It is powered by one or two RL10 rocket engines (SEC and DEC variants respectively).

Development history

Development started in 1956 at NASA's Lewis Research Center, now the Glenn Research Center, but proceeded slowly, with the first (unsuccessful) test flight in May 1962. In the late 1950s and early 1960s Centaur was proposed as a high energy upper stage for the Saturn I, Saturn IB and Saturn V rockets, under the designation S-V ("Saturn V") in accordance with the numbering of other stages of Saturn rockets. However, the first successful Centaur flight did not take place until 1965. By then, NASA had replaced the Centaur with much larger upper stages for the Saturn.

From 1966 to 1989, the Centaur-D was used as the upper stage for 63 Atlas rocket launches. Fifty-five of these launches were successful.[2]

From 1974 to 1977, the Centaur-D-1T was used as the third stage on seven Titan IIIE launches, six of which were successful.(Only the first launch, used to test the overall launch vehicle design rather than to launch a space vehicle, was classed as a failure; it did however, prove out the design.) Spacecraft launched by these vehicles included Viking 1, Viking 2, Voyager 1, Voyager 2, Helios 1 and Helios 2.[3]

A major change to the Centaur was made in the early 1980s. A hydrazine monopropellant attitude control system replaced the previous hydrogen peroxide system. The hydrogen peroxide powered boost pumps were deleted and the RL-10 engines fed directly via tank pressure — a significant reduction in system complexity.[4]


A new version, the Centaur-G, was developed for use with the Space Shuttle. It was optimized for installation in the Orbiter payload bay by increasing the hydrogen tank diameter to 14 feet while retaining the 10-foot-diameter (3.0 m) oxygen tank. Its initial mission was to boost the Galileo scientific probe to Jupiter.[5]

The Centaur, as carried in the Shuttle payload bay, required an extremely complex airborne support system, which was integrated into the Centaur Integrated Support System, the CISS. In addition to controlling Centaur pressurization in flight, the CISS had to be able to dump propellants overboard quickly in the event of a Return To Launch Site Abort, a capability needed to permit the Orbiter to land safely. After the Challenger accident, NASA realized that it was far too risky to fly the Centaur on the Shuttle.[5]

The decision to terminate the Shuttle/Centaur program spurred the United States Air Force to create the Titan IV, which, in its 401A/B versions, used the Centaur-T, also with a 14-foot-diameter (4.3 m) hydrogen tank, as its final stage. This vehicle was capable of launching payloads which had originally been designed for the Shuttle-Centaur combination. In the Titan 401A version, a Centaur-T was launched nine times between 1994 and 1998. In the Titan 401B version, a Centaur-T was launched seven times, with one failure, between 1997 and 2003. The last Titan-Centaur launch was in 2003.[6]

Another major Centaur reconfiguration was done for the Atlas III vehicle with a change from dual RL-10 engines as standard to a single RL-10. This change was accomplished while retaining the ability to revert to dual engines should mission requirements dictate. For most missions a single RL-10 is optimal (or adequate), hence a substantial reliability and cost benefit was realized.[4]p. 251.

A "Common Centaur" was unveiled by Lockheed Martin Space Systems on November 30, 1999. The stretched Centaur stage was 11.68 m in length, 1.7 m longer than the Centaur used on Atlas IIA and IIAS rockets at that time.[7]

Mishaps

Although Centaur has a long and successful history in planetary exploration, it has had its share of problems, especially early on:

  • May 8, 1962: Centaur weather shield separated early; stage exploded. Footage of this was used in the film Koyaanisqatsi.
  • June 30, 1964: RL-10 hydraulic actuator pump shaft broke, preventing one of the two RL-10 engines from vectoring. This led to no roll control, and uncovering of LOX inlet.
  • December 11, 1964: Restart attempt failed, due to problem with ullage rockets.
  • April 7, 1966: Centaur did not restart after coast — ullage motors ran out of fuel.
  • August 10, 1968: Centaur restart failed.
  • May 9, 1971; Centaur guidance failed, destroying itself and the Mariner 8 spacecraft bound for Mars orbit.
  • Feb 11, 1974: Titan-Centaur; boost pump failed.
  • June 9, 1984: Centaur LOX tank failed; no restart.
  • April 18, 1991: Centaur failed due to icing of hydrogen pump impeller blades (not understood at the time)
  • August 22, 1992: Centaur failed to restart (icing problem again)
  • April 30, 1999: Launch of the USA-143 (Milstar-3) communications satellite failed when a Centaur programming error resulted in incorrect burn times, placing the satellite in a useless orbit.[8]
  • June 15, 2007: the engine in the Centaur upper stage of an Atlas V shut down early, leaving its payload — a pair of National Reconnaissance Office ocean surveillance satellites — in a lower than intended orbit.[9] The failure was called "A major disappointment", though later statements claim the spacecraft will still be able to complete their mission.[10] The cause was traced to a stuck-open valve that depleted some of the hydrogen fuel, resulting in the second burn terminating four seconds early.[10] The problem was fixed[11] and the next flight was nominal.[12]

Current status

As of 2009, derivatives of the 10-foot-diameter (3.0 m) Centaur-3, with either one or two RL-10A4-2 engines, continue to be used as the upper stage of the Atlas V EELV rocket, the successor of the Titan-Centaur configuration.

Although ULA has an extensive launch manifest for future Centaur flights, ULA has been working on an upper stage design concept that would bring the Delta and Centaur stages together into a single new cryogenic second stage design. The Advanced Common Evolved Stage is intended as a lower-cost, more-capable and more-flexible upper stage that would supplement, and perhaps replace, the existing ULA (Lockheed Martin legacy) Centaur and the ULA (Boeing legacy) Delta Cryogenic Second Stage (DCSS) upper stage vehicles.[13]

Future uses

There was a possible use of the Centaur as an upper stage on the new Delta IV Heavy rocket, which started test flights in 2004, and may have even been used as a high-energy "kick motor" for planetary probes launched on board the 125-ton Ares V, which would have seen its first flight around 2018.[14]

The Centaur has a planned evolutionary upgrade which changes the tank diameter to 5.4 m and increases propellant load from 1.5 to 6.0 times that of the present Atlas V configuration. This diameter matches the existing Contraves-built 5.4 m payload fairing, thus eliminating many structural elements and permitting the vehicle to fly from existing launch complexes with minimal modifications. This design reverses the internal common bulkhead and streamlines many systems while permitting many existing systems and components to fly unchanged. Modular design enables multiple engine configurations from one to six RL-10s or up to three advanced next-generation high performance engines. This evolved Centaur can be flown either on existing Atlas boosters ( designated a Phase 1 configuration) or on next generation 5.4 m diameter boosters (designated Phase 2).

Performance levels for the Evolved Centaur based Phase 1 vehicles envelope all Atlas V capabilities. In certain circumstances a single Atlas booster vehicle with five solids and with an evolved Centaur upper-stage can replace a three-booster core Atlas V-Heavy (HLV). This has obvious reliability and cost benefits. Phase 2 vehicles open the door to a vastly higher performance capability. Up to 80 metric tons can be lifted to low earth orbit on a Phase 2 HLV vehicle — a substantial fraction of a Saturn V or Ares V vehicle. This performance level, mandated only by NASA crewed exploration missions, can be achieved using hardware identical to that used for traditional commercial and USG missions thus allowing development and support costs to be diluted by rate.

Studies have been conducted showing the extensibility of the basic Centaur and Evolved Centaur designs to long duration space flight for exploration purposes and even for use as a Lunar Lander. Complementing these basic performance capabilities is the ability to rate the vehicle for crewed operation. Extensive work has been conducted showing that achieving this "man-rating" is straightforward and does not mandate wholesale design changes to the Centaur vehicle.

Test bed for cryogenic fluid management experiments

By 2006, Lockheed Martin Space Systems had described the ability to use existing Centaur hardware, with little modification, as a test bed for in-space cryogenic fluid management techniques.[15] Most Centaurs launched on Atlas have excess propellants, ranging from hundreds to thousands of pounds, which could be used for "rideshare" experiments flown as secondary payloads conducted after separation of the primary spacecraft.

In October 2009, the Air Force and United Launch Alliance (ULA) performed an experimental on-orbit demonstration on a modified Centaur upper stage on the DMSP-18 launch to improve "understanding of propellant settling and slosh, pressure control, RL10 chilldown and RL10 two-phase shutdown operations. "The light weight of DMSP-18 allowed 12,000 pounds (5,400 kg) of remaining LO2 and LH2 propellant, 28% of Centaur’s capacity," for the on-orbit demonstrations. The post-spacecraft mission extension ran 2.4 hours before executing the deorbit burn.[16] The initial mission demonstration in 2009 was preparatory to the more-advanced cryogenic fluid management experiments planned for the Centaur-based CRYOTE technology development program in 2012-2014[17] and to a higher-TRL design for the Advanced Common Evolved Stage Centaur successor.[13]

Specifications

Source: Atlas V551 Specifications.[18]

  • Diameter: 3.05 m (10 ft)
  • Length: 12.68 m (42 ft)
  • Inert mass: 2,247 kg (4,954 lb)
  • Propellant: Liquid hydrogen
  • Oxidizer: Liquid oxygen
  • Fuel & oxidizer mass: 20,830 kg (45,922 lb)
  • Guidance: Inertial
  • Propulsion: 1 RL 10A-4-2
  • Thrust: 99.2 kN (22,300 lbf)
  • Engine length: 2.32 m (7.6 ft)
  • Engine diameter: 1.53 m (5 ft)
  • Engine dry weight: 168 kg (370 lb)
  • Burn time: Variable
  • Engine start: Restartable
  • Attitude control: 4 27-N thrusters, 8 40-N thrusters
  • Propellant: Hydrazine

References

External links

  • Gunter's Space Page — information on Centaur versions and launch list
  • Taming Liquid Hydrogen: The Centaur Upper Stage Rocket, 1958-2002 NASA History Publication.
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 


Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.