World Library  
Flag as Inappropriate
Email this Article

Hot wire barretter

Article Id: WHEBN0004495067
Reproduction Date:

Title: Hot wire barretter  
Author: World Heritage Encyclopedia
Language: English
Subject: Iron-hydrogen resistor, Wollaston wire, Memistor, Compactron, Dekatron
Collection:
Publisher: World Heritage Encyclopedia
Publication
Date:
 

Hot wire barretter

The hot wire barretter was a demodulating detector, invented in 1902 by Reginald Fessenden, that found limited use in early radio receivers. In effect it was a highly sensitive thermoresistor developed to permit the reception of amplitude modulated signals, something that the coherer (the standard detector of the time) could not do.[1]

The first device used to demodulate audio signals, it was later superseded by the electrolytic detector, also generally attributed to Fessenden. The barretter principle is still used as a detector for microwave radiation, similar to a bolometer.[2]

Description and construction

An extremely fine platinum wire, about 0.003 inches (0.08 mm) in diameter, is embedded in the middle of a silver wire having a diameter of about 0.1 inches (2.5 mm). This compound wire is then drawn until the silver wire had a diameter of about 0.002 inches (0.05 mm); as the platinum wire within it is reduced in the same ratio, it is drawn down to a final diameter of 0.00006 inches (1.5 µm). The result is called Wollaston wire.

The silver cladding is etched off a short piece of the composite wire, leaving an extremely fine platinum wire; this is supported, on two heavier silver wires, in a loop inside a glass bulb. The leads are taken out through the glass envelope and the whole device is put under vacuum and then sealed.

Operation

The hot wire barretter depends upon the variation (usually an increase) of a metal's resistivity as a function of increasing temperature. The device is biased by a direct current adjusted to heat the wire to its most sensitive temperature. When there is an oscillating current from the antenna through the extremely fine platinum wire loop, the wire is further heated as the current increases and cools as the current decreases again. As the wire heats and cools, it varies its resistance in response to the signals passing through it. Because of the low thermal mass of the wire, it is capable of responding quickly enough to vary its resistance in response to audio signals. However, it cannot vary its resistance fast enough to respond to much higher radio frequencies. The radio frequencies are essentially removed, and the sound is demodulated because the current through the circuit varies with the changing wire resistance. Headphones are connected in series with the D.C. circuit and the variations in the current are rendered as sound.

See also

External links

Patents

  • US 706744 , "Current Actuated Wave Responsive Device" – August, 1902 ("barretter" detector)
  • US 727331 , "Receiver for Electromagnetic Waves" – May, 1903 (improved "barretter")

Other

  • Detectors of electrical oscillations
  • Tech Definitions - Radio Concepts
  • United States Early Radio History
  • Secor, H. Winfield (January, 1917). Radio Detector Development. The Electrical Experimenter, pages 652+, accessed 2007-12-20.

References

  1. ^ History of Wireless Tapan K. Sarkar, Robert Mailloux, Arthur A. Oliner, Magdalena Salazar-Palma, Dipak L. Sengupta ISBN 978-0-471-78301-5 January 2006, Wiley-IEEE Press page 369
  2. ^ IEEE Std. 100 Dictionary of IEEE Standards Terms, 7th Ed. ISBN 0-7381-2601-2
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 


Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.