World Library  
Flag as Inappropriate
Email this Article

Kirchhoff's circuit laws

 

Kirchhoff's circuit laws

Kirchhoff's circuit laws are two Maxwell. Widely used in electrical engineering, they are also called Kirchhoff's rules or simply Kirchhoff's laws.

Both of Kirchhoff's laws can be understood as corollaries of the Maxwell equations in the low-frequency limit. They are accurate for DC circuits, and for AC circuits at frequencies where the wavelengths of electromagnetic radiation are very large compared to the circuits.

Contents

  • Kirchhoff's current law (KCL) 1
    • Uses 1.1
  • Kirchhoff's voltage law (KVL) 2
    • Generalization 2.1
  • Limitations 3
  • Example 4
  • See also 5
  • References 6

Kirchhoff's current law (KCL)

The current entering any junction is equal to the current leaving that junction. i2 + i3 = i1 + i4

This law is also called Kirchhoff's first law, Kirchhoff's point rule, or Kirchhoff's junction rule (or nodal rule).

The principle of conservation of electric charge implies that:

At any node (junction) in an electrical circuit, the sum of currents flowing into that node is equal to the sum of currents flowing out of that node

or equivalently

The algebraic sum of currents in a network of conductors meeting at a point is zero.

Recalling that current is a signed (positive or negative) quantity reflecting direction towards or away from a node, this principle can be stated as:

\sum_{k=1}^n {I}_k = 0

n is the total number of branches with currents flowing towards or away from the node.

This formula is valid for complex currents:

\sum_{k=1}^n \tilde{I}_k = 0

The law is based on the conservation of charge whereby the charge (measured in coulombs) is the product of the current (in amperes) and the time (in seconds).

Uses

A matrix version of Kirchhoff's current law is the basis of most circuit simulation software, such as SPICE. Kirchhoff's current law combined with Ohm's Law is used in nodal analysis.

KCL is applicable to any lumped network irrespective of the nature of the network; whether unilateral or bilateral, active or passive, linear or non-linear.

Kirchhoff's voltage law (KVL)

The sum of all the voltages around a loop is equal to zero.
v1 + v2 + v3 - v4 = 0

This law is also called Kirchhoff's second law, Kirchhoff's loop (or mesh) rule, and Kirchhoff's second rule.

The principle of conservation of energy implies that

The directed sum of the electrical potential differences (voltage) around any closed network is zero, or:
More simply, the sum of the emfs in any closed loop is equivalent to the sum of the potential drops in that loop, or:
The algebraic sum of the products of the resistances of the conductors and the currents in them in a closed loop is equal to the total emf available in that loop.

Similarly to KCL, it can be stated as:

\sum_{k=1}^n V_k = 0

Here, n is the total number of voltages measured. The voltages may also be complex:

\sum_{k=1}^n \tilde{V}_k = 0

This law is based on the conservation of energy whereby voltage is defined as the energy per unit charge. The total amount of energy gained per unit charge must be equal to the amount of energy lost per unit charge, as energy and charge are both conserved.

Generalization

In the low-frequency limit, the voltage drop around any loop is zero. This includes imaginary loops arranged arbitrarily in space – not limited to the loops delineated by the circuit elements and conductors. In the low-frequency limit, this is a corollary of Faraday's law of induction (which is one of the Maxwell equations).

This has practical application in situations involving "static electricity".

Limitations

KCL and KVL both depend on the lumped element model being applicable to the circuit in question. When the model is not applicable, the laws do not apply.

KCL, in its usual form, is dependent on the assumption that current flows only in conductors, and that whenever current flows into one end of a conductor it immediately flows out the other end. This is not a safe assumption for high-frequency AC circuits, where the lumped element model is no longer applicable.[2] It is often possible to improve the applicability of KCL by considering "parasitic capacitances" distributed along the conductors.[2] Significant violations of KCL can occur[3] even at 60Hz, which is not a very high frequency.

In other words, KCL is valid only if the total electric charge, \scriptstyle Q , remains constant in the region being considered. In practical cases this is always so when KCL is applied at a geometric point. When investigating a finite region, however, it is possible that the charge density within the region may change. Since charge is conserved, this can only come about by a flow of charge across the region boundary. This flow represents a net current, and KCL is violated.

KVL is based on the assumption that there is no fluctuating magnetic field linking the closed loop. This is not a safe assumption for high-frequency (short-wavelength) AC circuits.[2] In the presence of a changing magnetic field the electric field is not a conservative vector field. Therefore the electric field cannot be the gradient of any potential. That is to say, the line integral of the electric field around the loop is not zero, directly contradicting KVL.

It is often possible to improve the applicability of KVL by considering "parasitic inductances" (including mutual inductances) distributed along the conductors.[2] These are treated as imaginary circuit elements that produce a voltage drop equal to the rate-of-change of the flux.

Example

Assume an electric network consisting of two voltage sources and three resistors.

According to the first law we have

i_1 - i_2 - i_3 = 0 \,

The second law applied to the closed circuit s1 gives

-R_2 i_2 + \mathcal{E}_1 - R_1 i_1 = 0

The second law applied to the closed circuit s2 gives

-R_3 i_3 - \mathcal{E}_2 - \mathcal{E}_1 + R_2 i_2 = 0

Thus we get a linear system of equations in i_1, i_2, i_3:

\begin{cases} i_1 - i_2 - i_3 & = 0 \\ -R_2 i_2 + \mathcal{E}_1 - R_1 i_1 & = 0 \\ -R_3 i_3 - \mathcal{E}_2 - \mathcal{E}_1 + R_2 i_2 & = 0 \end{cases}

Which is equivalent to

\begin{cases} i_1 + - i_2 + - i_3 & = 0 \\ R_1 i_1 + R_2 i_2 + 0 i_3 & = \mathcal{E}_1 \\ 0 i_1 + R_2 i_2 - R_3 i_3 & = \mathcal{E}_1 + \mathcal{E}_2 \end{cases}

Assuming

R_1 = 100,\ R_2 = 200,\ R_3 = 300\text{ (ohms)};\ \mathcal{E}_1 = 3,\ \mathcal{E}_2 = 4\text{ (volts)}

the solution is

\begin{cases} i_1 = \frac{1}{1100} \\[6pt] i_2 = \frac{4}{275} \\[6pt] i_3 = - \frac{3}{220} \end{cases}

i_3 has a negative sign, which means that the direction of i_3 is opposite to the assumed direction (the direction defined in the picture).

See also

References

  1. ^ Oldham, Kalil T. Swain (2008). The doctrine of description: Gustav Kirchhoff, classical physics, and the "purpose of all science" in 19th-century Germany (Ph. D.). University of California, Berkeley. p. 52. Docket 3331743. 
  2. ^ a b c d Ralph Morrison, Grounding and Shielding Techniques in Instrumentation Wiley-Interscience (1986) ISBN 0471838055
  3. ^ simonjz05,. "High Voltage Cable Inspection" (video). 
  • Paul, Clayton R. (2001). Fundamentals of Electric Circuit Analysis. John Wiley & Sons.  
  • Serway, Raymond A.; Jewett, John W. (2004). Physics for Scientists and Engineers (6th ed.). Brooks/Cole.  
  • Tipler, Paul (2004). Physics for Scientists and Engineers: Electricity, Magnetism, Light, and Elementary Modern Physics (5th ed.). W. H. Freeman.  
  • Graham, Howard Johnson, Martin (2002). High-speed signal propagation : advanced black magic (10. printing. ed.). Upper Saddle River, NJ: Prentice Hall PTR.  
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 


Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.