World Library  
Flag as Inappropriate
Email this Article

Northrop X-21

 

Northrop X-21

X-21
Northrop X-21A
Role experimental aircraft
Manufacturer Northrop
First flight 18 April 1963
Introduction experimental
Retired 1968
Primary user National Aeronautics and Space Administration (NASA)
Number built 2
Developed from Douglas B-66 Destroyer

The Northrop X-21A was an experimental aircraft designed to test wings with laminar flow control. It was based on the Douglas WB-66D airframe, with the wing-mounted engines moved to the rear fuselage and making space for air compressors. The aircraft first flew on 18 April 1963 with NASA test pilot Jack Wells at the controls.[1] Although useful testing was accomplished, the extensive maintenance of the intricate laminar-flow system caused the end of the program.

Contents

  • Design and development 1
  • Testing 2
  • Disposition 3
  • Specifications (X-21A) 4
  • See also 5
  • References 6
  • External links 7

Design and development

Laminar-flow control is a technology that offers the potential for significant improvement in drag coefficient which would provide improvements in aircraft fuel usage, range or endurance that far exceed any known single aeronautical technology. In principle, if 80 percent of wing is laminar, then overall drag could be reduced by 25 percent. The frictional force between the air and the aircraft surface, known as viscous drag, is much larger in a turbulent boundary layer than in a laminar one. The principal type of active laminar-flow control is removal of a small amount of the boundary-layer air by suction through porous materials, multiple narrow surface slots, or small perforations (boundary layer suction).

Two major modifications were required, the first involving the standard underwing podded Allison J71 engines being removed and replaced by a pair of 9,490 lbf (42 kN) static thrust General Electric XJ79-GE-13 non-afterburning turbojets mounted in pods attached to the rear of the fuselage sides. Bleed air from the J79 engines was fed into a pair of underwing fairings, each of which housed a "bleed-burn" turbine which sucked the boundary layer air out through the wing slots.

The X-21A test vehicles (55-0408 and 55-0410) also incorporated sophisticated laminar flow control systems built into a completely new wing of increased span and area, with a sweep reduced from 35° to 30°. The wing had a multiple series of span-wise slots (800,000 in total [2]) through which turbulent boundary-layer was "sucked in," resulting in a smoother laminar flow. Theoretically, reduced drag, better fuel economy and longer range could be achieved.[3]

The forward cockpit carried a pilot and two flight engineers while two additional flight test engineers were housed in a central fuselage bay underneath the wing.

Testing

X-21A in testing

In initial testing there were significant problems with the porous materials and surface slots getting plugged with debris, bugs, even rain. In certain conditions, ice crystals would form due to the rapid cooling of air over those laminar surfaces abruptly disrupting laminar flow, causing rapid melting and rapid transition back to turbulent flow. Maximum achievement of 95 percent laminar flow over those areas was desired.[2] However, the design effort was canceled due to the plugging problems.

Nevertheless, pioneering data was obtained in the X-21 flight program, including the effects of surface irregularities, boundary-layer turbulence induced by three-dimensional span-wise flow effects in the boundary layer (referred to as span-wise contamination) and degrading environmental effects such as ice crystals in the atmosphere.[4]

Disposition

Both X-21As ended up in storage at Edwards Air Force Base, California where gradually, they became derelicts, used primarily as photo targets. The remains can still be viewed but no efforts have been made to recover a single example for restoration or display.[2][5]

Specifications (X-21A)

The X-21A lifts off on its first flight

General characteristics

Performance

See also

Related development

References

Notes
  1. ^ American X-Vehicles: An Inventory, June 2003. Retrieved: 13 February 2007..
  2. ^ a b c Winchester 2005 p. 297.
  3. ^ Baugher, Joe. Northrop X-21A Retrieved: 14 February 2007.
  4. ^ Chambers, Joseph R. Laminar-flow Control: The Holy Grail of Aerodynamics NASA, p. 133–134.
  5. ^ Jenkins, Dennis R. X-Planes Photo Scrapbook. North Branch, Minnesota: Specialty Press, 2004. ISBN 1-58007-076-0
Bibliography
  • Winchester, Jim. X-Planes and Prototypes. London: Amber Books Ltd., 2005. ISBN 1-904687-40-7.
  • "X-Planes Detailed Data - Northrop X-21A" Retrieved: 14 February 2007.

External links

  • Globasecurity.org - X-21 Laminar Flow Control
  • aeroweb.brooklyn.cuny.edu - Northrop X-21A
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 


Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.