Overburn

Optical disc authoring requires a number of different optical disc recorder technologies working in tandem, from the optical disc media to the firmware to the control electronics of the optical disc drive. This article discusses some of the more important technologies.

Types of recordable optical disc

There are numerous formats of recordable optical direct to disk on the market, all of which are based on using a laser to change the reflectivity of the digital recording medium in order to duplicate the effects of the pits and lands created when a commercial optical disc is pressed. Emerging technologies such as holographic data storage and 3D optical data storage aim to use entirely different data storage methods, but these products are in development and are not yet widely available.

The earliest form is magneto-optical, which uses a magnetic field in combination with a laser to write to the medium. Though not widely used in consumer equipment, the original NeXT cube used MO media as its standard storage device, and consumer MO technology is available in the form of Sony's MiniDisc. This form of medium is rewriteable.

The most common form of recordable optical media is write-once organic dye technology, popularized in the form of the CD-R and still used for higher-capacity media such as DVD-R. This uses the laser alone to scorch a transparent organic dye (usually cyanine, phthalocyanine, or azo compound-based) to create "pits" (i.e. dark spots) over a reflective spiral groove. Most such media are designated with an R (recordable) suffix. Such discs are often quite colorful, generally coming in shades of blue or pale yellow or green.

Rewritable, non-magnetic optical media are possible using phase change alloys, which are converted between crystalline and amorphous states (with different reflectivity) using the heat from the drive laser. Such media must be played in specially tuned drives, since the phase-change material has less of a contrast in reflectivity than dye-based media; while most modern drives support such media, many older CD drives cannot recognize the narrower threshold and cannot read such discs. Phase-change discs are designated with RW (ReWriteable) or RE (Recordable-Erasable). Phase-change discs often appear dark grey.

A new technology has emerged whereby physical changes to a long-lived media creates a new "write-once" option. A drive offered by Millenniata is supposed to record data on proprietary media with a data life-time said to be "forever".[1]

Optimum Power Calibration

Optimum Power Calibration (OPC) is a function that checks the proper laser power for writing a particular session in the media in use. More sophisticated is Active OPC, which calculates the optimum laser power and adjusts it in real-time.

Recording modes

Optical discs can be recorded in Disc At Once, Track At Once, Session at Once (i.e. multiple burning sessions for one disc), or packet writing modes. Each mode serves different purposes:

  • Disc At Once: writes the entire disc in one pass; preferred for duplication masters
  • Track At Once: writes individual tracks with a gap between tracks; used for audio CDs
  • Session At Once: writes and finalizes multiple sessions on one CD; usually not supported for CD Audio, and not universally supported by authoring software
  • Packet writing: writes data to the medium on demand (see below)

Connection technologies

Unlike early CD-ROM drives, optical disc recorder drives have generally used industry standard connection protocols. Early computer-based CD recorders were generally connected by way of SCSI; however, as SCSI was abandoned by its most significant users (particularly Apple Computer), it became an expensive option for most computer users. As a result, the market switched over to Parallel ATA connections for most internal drives; external drives generally use PATA drive mechanisms connected to a bridge inside the case that connects to a high-speed serial bus such as FireWire or Hi-Speed USB 2.0. A few, but becoming more and more common, very high-speed drives, mostly DVD recorders, use Serial ATA.

Standalone recorders use standard A/V connections, including RCA connectors, TOSlink, and S/PDIF for audio and RF, composite video, component video, S-Video, SCART, and FireWire for video. High-bandwidth digital connections such as HDMI are not yet commonplace.

Overburning

Overburning is the process of recording data past the normal size limit. Structures in the ATIP do not allow such sizes to be specified.

Buffer underrun protection

Usually, the recorder must perform a complete write without pauses. Once the laser is on, stopping and restarting the recording process may introduce flaws.

A buffer underrun occurs during recording if the supply of data to the recorder is interrupted before the write is complete. Software typically moves the data to be recorded into a buffer; underrun occurs if the recorder processes data in the buffer faster than the software reloads it. Historically, buffer underrun was often caused by writing data obtained from a slow device, or by slowness of the recording software, from a slow processor or a processor executing other tasks concurrently.

Various recorders minimize or cope with buffer underrun in the following ways:

  • Nearly all burners can slow the rotation of the disc and record at a slower rate. A burner may do so on sensing that it is drawing down the data in the buffer faster than software is reloading it.
  • Recording software maintains larger buffers than when CD recorders were first introduced. Some recorders maintain their own buffer memory independently of the computer. This additional buffering ensures that momentary pauses in the supply of data do not cause buffer underrun.
  • Some recorders are, in fact, able to stop writing in the middle of a session, and resume writing whenever the buffer is refilled. Recorders with such buffer underrun protection handle the interruption with an extremely small gap in the recorded track on the disc.[2]

Since the techniques for protecting against buffer underrun are proprietary and vendor-specific, technical details vary.

Buffer underrun is minimized by a strategy in which the recorder burns a packet rather than an entire session or an entire disc. When using rewritable media (CD-RW, DVD-RW, DVD-RAM), the UDF file system organizes the disc into packets that are written individually. The packets are referenced by a single, updated address table.

Packet writing

Main article: Packet writing

Packet writing is a technology that allows optical discs to be used in a similar manner to a floppy disk. Packet writing can be used both with once-writeable media and rewriteable media. Several competing and incompatible packet writing disk formats have been developed, including DirectCD and InCD. The standardized formats for packet writing are the Universal Disk Format in the plain, VAT, and spared builds.

Specific proprietary technologies

BURN-Proof

BURN-Proof (Buffer Underrun-Proof) is a proprietary technology for buffer underrun protection developed by Sanyo.[3]

SafeBurn

SafeBurn is a proprietary technology for buffer underrun protection developed by Yamaha Corporation.

Power Burn

Power Burn is a proprietary technology for buffer underrun protection, developed by Sony. Features:

  • Buffer underrun protection: When a buffer underrun occurs, the drive suspends writing. The drive memorizes the end writing point and timing, and immediately resumes writing from that exact point when sufficient data is filled in the buffer memory.
  • Protection from write errors caused by shock and vibration: PowerBurn's Shock Proof technology pauses writing when the device is moved, and resumes after the drive becomes stable. This allows it to work in a mobile environment.
  • Optimization of write conditions: The drive detects characteristics of each individual medium and optimizes all key writing conditions such as writing speed, laser power and write strategy.

JustSpeed

JustSpeed is a technology that automatically adapts the write speed to the medium inserted. It is supported by Nero Burning ROM version 6.

Longevity

Retail recordable/writable optical media contain dyes in/on the optical media to record data, whereas factory-manufactured optical media use physical "pits" created by plastic molds/casts. As a result, data storage on retail optical media does not have the life-span of factory-manufactured optical media. One must therefore be wary of storing family photos and videos (or any other miscellaneous important data) solely on dye-based optical media. MAM-A (Mitsui) claims a life of 300 years on their archival gold CD-R and 100 years for gold DVDs. Good alternatives would be to additionally backup one's media using other media technologies and/or investing in non-volatile memory technologies.[4]

References

External links

  • Understanding CD-R & CD-RW by Hugh Bennett
  • Understanding Recordable & Rewritable DVD by Hugh Bennett
  • Burning For The Long Haul
  • CD and DVD Longevity: How Long Will They Last?
  • Blu Ray Technology
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.