World Library  
Flag as Inappropriate
Email this Article

Junction temperature

Article Id: WHEBN0012008694
Reproduction Date:

Title: Junction temperature  
Author: World Heritage Encyclopedia
Language: English
Subject: Thermal management of high-power LEDs, Operating temperature, Thermal design power, Semiconductors, Thermal resistance
Collection:
Publisher: World Heritage Encyclopedia
Publication
Date:
 

Junction temperature

Junction temperature is the highest operating temperature of the actual semiconductor in an electronic device. In operation, it is higher than case temperature and the temperature of the part's exterior. The difference is equal to the amount of heat transferred from the junction to case multiplied by the junction-to-case thermal resistance.

Microscopic effects

Various physical properties of semiconductor materials are temperature dependent. These include the diffusion rate of dopant elements, carrier mobilities and the thermal production of charge carriers.

At the low end, sensor diode noise can be reduced by cryogenic cooling. On the high end, the resulting increase in local power dissipation can lead to thermal runaway that may cause momentary or permanent device failure.

Maximum junction temperature

Maximum junction temperature (sometimes abbreviated TJMax) is specified in a part's datasheet and is used when calculating the necessary case-to-ambient thermal resistance for a given power dissipation. This in turn is used to select an appropriate heat sink if necessary. Other cooling methods include thermoelectric cooling and Coolants.

In Intel processors, the core temperature is measured by a sensor. If the core reaches its TJMax, this will trigger a protection mechanism to cool the processor. If the temperature rises above the TJMax, the processor will trigger an alarm to warn the computer operator who can then discontinue the process that is causing the overheating or shut down the computer to prevent damage.[1]

An estimation of the chip-junction temperature, TJ, can be obtained from the following equation:[2]

TJ = TA + ( R θJA × PD )...

where: TA = ambient temperature for the package ( °C )

R θJA = junction to ambient thermal resistance ( °C / W )

PD = power dissipation in package (W)

See also

References

  1. ^ Vol.3A: System Programming GuideSoftware Developer's ManualRudolf Marek, "Datasheet: Intel 64 and IA-32 Architectures",
  2. ^


This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 


Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.