World Library  
Flag as Inappropriate
Email this Article


Article Id: WHEBN0000904251
Reproduction Date:

Title: Travan  
Author: World Heritage Encyclopedia
Language: English
Subject: TR6, Digital Data Storage, Quarter-inch cartridge, Magnetic tape data storage, Magnetic tape data formats
Collection: Computer Storage Tape Media
Publisher: World Heritage Encyclopedia


A Travan tape cartridge shown next to a CD-R disc.

Travan is an 8 mm magnetic tape cartridge design developed by the 3M company, used for the storage of data in computer backups and mass storage.[1] Over time, subsequent versions of Travan cartridges and drives have been developed that provide greater data capacity, while retaining the standard 8 mm width and 750' length. Travan is standardized under the QIC body. HP Colorado, Iomega DittoMax and AIWA Bolt are proprietary versions of the Travan format.

The Travan format competes mainly against the DDS, AIT, and VXA formats.


  • Generations 1
    • TR-1 1.1
    • TR-2 1.2
    • TR-3 1.3
    • TR-4 1.4
    • TR-5 1.5
    • TR-7 1.6
  • Technology 2
  • References 3
  • External links 4


Generation TR-1 TR-3 TR-4 TR-5/NS20 TR-7
Release date 1995 1995 1997 1998 2002
Data capacity 400 MB 1.6 GB 4 GB 10 GB 20 GB
Max speed (MB/s) 0.25 0.5 1.2 2 4
Media format QIC-80 QIC-3020 QIC-3095 QIC-3220-MC Travan 640
Min tape length (ft) 750 750 740 740 750
Tape tracks 36 50 72 108 108
Encoding MFM MFM RLL(1,7) RLL(1,7) VR2 (PRML)
Tape type Co-γFe2O3 Co-γFe2O3 Co-γFe2O3 Metal Particle Metal Particle
Coercivity (Oe) 550 900 900 1650 1650
Recording density (ftpi) 14,700 44,250 50,800 79,800 96,000
Data density (bpi) 14,700 44,250 67,733 106,400 192,000[2]


  • Travan TR-1 cartridges offer a 400 MB native capacity with a 0.25 MB/s transfer rate using the QIC-80 media format.


  • TR-2 was designed by 3M, but they never marketed it.
  • TR-2 cartridges were designed to have an 800 MB native capacity with a 0.25 MB/s transfer rate using the QIC-3010 media format.
  • The spec called for 50 tracks across the tape, with a recording density of 22,125 flux transitions per inch (ftpi).


  • Travan TR-3 cartridges offer a 1.6 GB native capacity with a 0.5 MB/s transfer rate using the QIC-3020 media format.


  • Travan TR-4 cartridges offer a 4 GB native capacity using the QIC-3095 media format.
  • Travan 8 GB cartridges offer a 4 GB native capacity with a 1.2 MB/s transfer rate.
  • Travan NS8 cartridges offer a 4 GB native capacity with a 1.2 MB/s transfer rate.
  • Imation HP Colorado 5 GB is a 460 ft (140 m) variation on the TR-4 standard. It offered 2.5 GB native capacity, 1 MB/s transfer rate.


An external, USB, NS20 Travan tape drive.
  • Travan NS20 cartridges offer a 10 GB native capacity with a 2 MB/s transfer rate.
  • Travan 20 GB cartridges offer a 10 GB native capacity with a 2 MB/s transfer rate.


  • Travan 40 GB cartridges offer a 20 GB native capacity with a 4 MB/s transfer rate.


Travan uses a linear track technology, with data written onto individual tracks over several successive passes. Fully reading or writing a tape to full capacity may require moving the tape from reel to reel many times. The tape is not attached to the hubs, but is wrapped and held by friction. The tape is prevented from coming off at the ends using small holes punched in the tape, which are detected by optical sensors in the tape drive using a 45-degree mirror inside and a window on the side the cartridge.

It also uses an indirect tension-band drive system, consisting of an elastic band that presses on the exterior of both reels, and also over an idler wheel on the edge of the case. A motor in the drive contacts the idler to move the tape. Because the reels wind and unwind at unequal speeds there is always some slippage occurring when the tape is in motion. Old tapes used many times tend to have a visibly marked stripe down the center of the tape where the band has pressed into the tape.

Unlike some competing technologies such as Digital Linear Tape (DLT) and Linear Tape-Open (LTO), Travan technology does not automatically verify data after writing. Data verification must be done separately by the computer operator, to verify data was written successfully. If a separate verify operation is not performed after each backup, it is possible for backups to be found to be corrupt and unusable when the tapes need to be used.


  1. ^ Scott Mueller (2004). Upgrading and Repairing PCs. p. 683. 
  2. ^ Seagate Travan 40 Product Manual (PDF). Seagate Removable Storage Solutions LLC. 2002. p. 5. 

External links

  • Imation - Travan Data Cartridges
  • Imation - Flyer with cartridge specs
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.

Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.