World Library  
Flag as Inappropriate
Email this Article

Band-stop filter

Article Id: WHEBN0000380487
Reproduction Date:

Title: Band-stop filter  
Author: World Heritage Encyclopedia
Language: English
Subject: Band-pass filter, Filter (signal processing), All-pass filter, Waveguide filter, High-pass filter
Collection: Filter Frequency Response, Linear Filters, Synthesiser Modules
Publisher: World Heritage Encyclopedia

Band-stop filter

A generic ideal band-stop filter, showing both positive and negative angular frequencies

In signal processing, a band-stop filter or band-rejection filter is a filter that passes most frequencies unaltered, but attenuates those in a specific range to very low levels. It is the opposite of a band-pass filter. A notch filter is a band-stop filter with a narrow stopband (high Q factor).

Narrow notch filters (optical) are used in Raman spectroscopy, live sound reproduction (public address systems, or PA systems) and in instrument amplifiers (especially amplifiers or preamplifiers for acoustic instruments such as acoustic guitar, mandolin, bass instrument amplifier, etc.) to reduce or prevent audio feedback, while having little noticeable effect on the rest of the frequency spectrum (electronic or software filters). Other names include 'band limit filter', 'T-notch filter', 'band-elimination filter', and 'band-reject filter'.

Typically, the width of the stopband is 1 to 2 decades (that is, the highest frequency attenuated is 10 to 100 times the lowest frequency attenuated). However, in the audio band, a notch filter has high and low frequencies that may be only semitones apart.

Generic electrical schematic of a simple band-stop filter


  • Examples 1
    • In the audio domain 1.1
    • In the radio frequency (RF) domain 1.2
    • In the optical domain 1.3
  • See also 2
  • Notes 3
  • References 4


In the audio domain

Anti-hum filter

For countries using 60 Hz power lines:

  • Low Freq: 59 Hz
  • Middle Freq 60 Hz
  • High Freq: 61 Hz

This means that the filter passes all frequencies, except for the range of 59–61 Hz. This would be used to filter out the mains hum from the 60 Hz power line, though its higher harmonics could still be present.

For countries where power transmission is at 50Hz, the filter would have a 49–51 Hz range.

Anti-presence filter

  • Low Freq: 1 kHz
  • High Freq: 4 kHz

For attenuating presence.

In the radio frequency (RF) domain

Non-linearities of power amplifiers

When measuring the non-linearities of power amplifiers, a very narrow notch filter can be very useful to avoid the carrier frequency. Use of the filter may ensure that the maximum input power of a spectrum analyser used to detect spurious content will not be exceeded.

Wave trap

A notch filter, usually a simple LC circuit, is used to remove a specific interfering frequency. This is a technique used with radio receivers that are so close to a transmitter that it swamps all other signals. The wave trap is used to remove, or greatly reduce, the signal from the local transmitter.[1]

In the optical domain

Optical notch filters rely on destructive interference.

See also


  1. ^ Joseph J. Carr, The technician's radio receiver handbook: wireless and telecommunication technology, p.282, Newnes, 2001 ISBN 0-7506-7319-2.


 This article incorporates public domain material from the General Services Administration document "Federal Standard 1037C" (in support of MIL-STD-188).

This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.

Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.