Moving Micro Cross

A magnetic cartridge is a transducer used for the playback of gramophone records on a turntable or phonograph. It converts mechanical vibrational energy from a stylus riding in a record groove into an electrical signal that is subsequently amplified and then converted back to sound by a loudspeaker system.


The first commercially successful type of electrical phonograph pickup was introduced in 1925. Although electromagnetic, its resemblance to later magnetic cartridges is remote: it contained a bulky horseshoe magnet and employed the same imprecisely mass-produced single-use steel needles which had been standard since the first crude disc record players appeared in the 1890s. Its tracking weight was specified in ounces, not grams. This early type of magnetic pickup completely dominated the market well into the 1930s, but by the end of that decade it had been superseded by a comparatively lightweight piezoelectric crystal pickup type. The use of short-lived disposable metal needles remained standard. During the years of affluence and long-deferred consumer demand immediately following World War II, as old record players with very heavy pickups were replaced, precision-ground and conveniently long-lasting stylus tips made of sapphire or exotic hard metals such as osmium were increasingly popular. However, records made for home use still played at 78 rpm and most of them were still made of the same old abrasive shellac compound formulated to rapidly wear down the points of steel needles to fit the groove.

The introduction of the 33 rpm vinyl LP "album" in 1948 and the 45 rpm vinyl "single" in 1949 prompted consumers to upgrade to a new multi-speed record player with the required smaller-tipped "microgroove" stylus. Sapphire and diamond then became the standard stylus tip materials. At first, the new styli came installed in smaller, lighter piezoelectric crystal or ceramic cartridges of the general type found in inexpensive self-contained portable record players throughout the vinyl era. Ceramic cartridges continue to be used in most of the "retro" and compact record players currently being made, in part because they are comparatively robust and resistant to damage from careless handling. However, during the 1950s, a new generation of small, lightweight, highly compliant magnetic cartridges appeared and quickly found favor among high-fidelity enthusiasts because of their audibly superior performance. The high compliance also reduced record wear. They soon became standard in all but the cheapest component audio systems and are the most common type of pickup cartridge in use today.


In high-fidelity systems, crystal and ceramic pickups have been replaced by the magnetic cartridge, using either a moving magnet or a moving coil.

Compared to the crystal and ceramic pickups, the magnetic cartridge usually gives improved playback fidelity and reduced record wear by tracking the groove with lighter pressure. Magnetic cartridges use lower tracking forces and thus reduce the potential for groove damage. They also have a lower output voltage than a crystal or ceramic pickup, in the range of only a few millivolts, thus requiring greater amplification.

Moving Magnet (MM) and Moving Iron (MI) cartridges

In a moving magnet cartridge, the stylus cantilever carries a tiny permanent magnet, which is positioned between two sets of fixed coils (in a stereophonic cartridge), forming a tiny electromagnetic generator. As the magnet vibrates in response to the stylus following the record groove, it induces a tiny current in the coils.

Because the magnet is small and has little mass, and is not coupled mechanically to the generator (as in a ceramic cartridge), a properly adjusted stylus follows the groove more faithfully while requiring less tracking force (the downward pressure on the stylus).

Moving iron and induced magnet types (ADC being a well-known example) have a moving piece of iron or other ferrous alloy is coupled to the cantilever (instead of a magnet), while a permanent, bigger magnet is over the coils, providing the necessary magnetic flux.

Moving Coil (MC) cartridges

The MC design is again a tiny electromagnetic generator, but (unlike an MM design) with the magnet and coils reversed: the coils are attached to the stylus, and move within the field of a permanent magnet. The coils are tiny and made from very fine wire.

Since the number of windings that can be supported in such armature is small, the output voltage level is correspondingly small. The resulting signal is only a few hundred microvolts, and thus more easily swamped by noise, induced hum, etc. Thus it is more challenging to design a preamplifier with the extremely low noise inputs needed for moving-coil cartridge, therefore a "step up transformer" is sometimes used instead.

However, there are available many "high output" moving coil cartridges that have output levels similar to MM cartridges.

Moving coil cartridges are extremely small precision instruments and are therefore generally expensive, but are frequently preferred by audiophiles due to a subjectively better performance.

Moving Micro Cross (MMC) cartridges

The MMC design was invented and patented by Bang & Olufsen. The MMC cartridge is variation of the Moving Iron (MI) design. Magnets and coils are stationary while a micro cross moves with the stylus, thereby varying the distances between the arms of the cross and the magnets. It is claimed that the MMC design allows for superior channel separation, since each channel's movements appear on a separate axis.

Moving Magnet vs. Moving Coil debate

Moving magnet cartridges are more commonly found at the 'lower-end' of the market, while the 'higher-end' tends to be dominated by moving coil designs. The debate as to whether MM or MC designs can ultimately produce the better sound is often heated and subjective. The distinction between the two is often blurred by cost and design considerations - e.g. can an MC cartridge requiring another step-up amplification outperform well made MM cartridges that need simpler front-end stages?

  • MC cartridges offer very low inductance and impedance, which means that the effects of capacitance (in the cable that goes from the cartridge to the preamp) are negligible, unlike MM cartridges, which comparatively sport very high inductance and impedance. In the latter, cable capacitance can negatively affect the flatness of frequency response and linearity of phase response. This would account for a sonic advantage to MC types.
  • It is generally believed that MC cartridges sport lower moving masses. However, quality MM cartridges are able to offer as low or lower moving mass than some MC cartridges. For example, the state-of-the-art Technics EPC-100CMK4 with 0.055 mg of effective tip mass, of moving magnet design. Comparatively, the popular Denon DL-301 moving coil cartridge has an effective tip mass of 0.270 mg.
  • To discriminate cartridges by engine (MC vs MM) overlooks the fact that the stylus tip shape and cantilever have a significant influence in the sound, and this may account for more variation of sound quality than the engine type used.

"London Decca" Cartridges

The Decca phono cartridges were a unique design, with fixed magnets and coils. The stylus shaft was composed of the diamond tip, a short piece of soft iron, and an L-shaped cantilever made of non-magnetic steel. Since the iron was placed very close to the tip (within 1 mm), the motions of the tip could be tracked very accurately. Decca engineers called this "positive scanning". Vertical and lateral compliance was controlled by the shape and thickness of the cantilever. Decca cartridges had a reputation for being very musical; however early versions required more tracking force than competitive designs - making record wear a concern.

External links

  • Cartridge history from a 1958 bookde:Tonabnehmer

fr:Cellule magnétique sv:Tonhuvud it:Testina fonografica pt:Cápsula fonocaptora

This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.