World Library  
Flag as Inappropriate
Email this Article


Article Id: WHEBN0003393903
Reproduction Date:

Title: Pushback  
Author: World Heritage Encyclopedia
Language: English
Subject: Tug (disambiguation), U-30 Tow Tractor, 2006 O'Hare International Airport UFO sighting, Shear pin, Powerback
Collection: Aircraft Ground Handling, Articles Containing Video Clips, Tractors
Publisher: World Heritage Encyclopedia


A Cargolux Boeing 747-400 F being pushed back by tractor
Airbus A380 pushback

In aviation, pushback is an airport procedure during which an aircraft is pushed backwards away from an airport gate by external power. Pushbacks are carried out by special, low-profile vehicles called pushback tractors or tugs.

Although many aircraft are capable of moving themselves backwards on the ground using reverse thrust (a procedure referred to as a powerback), the resulting jet blast or prop wash may cause damage to the terminal building or equipment. Engines close to the ground may also blow sand and debris forward and then suck it into the engine, causing damage to the engine. A pushback is therefore the preferred method to move the aircraft away from the gate.


Pushbacks at busy aerodromes are usually subject to ground control clearance to facilitate ground movement on taxiways. Once clearance is obtained, the pilot will communicate with the pushback tractor driver (or a ground handler walking alongside the aircraft in some cases) to start the pushback. To communicate, a headset may be connected near the nose gear.

Since the pilots cannot see what is behind the aircraft, steering is done by the pushback tractor driver and not by the pilots. Depending on the aircraft type and airline procedure, a bypass pin may be temporarily installed into the nose gear to disconnect it from the aircraft's normal steering mechanism.

Once the pushback is completed, the towbar is disconnected, and the bypass pin is removed. The ground handler will show the bypass pin to the pilots to make it absolutely clear that it has been removed. The pushback is then complete, and the aircraft can start taxiing forward under its own power.


The simplest way to ground handle an aircraft. This Aerotechnik EV-97A Eurostar is being pulled into position for refueling

Very small airplanes may be moved by human power alone. The airplane may be pushed or pulled by landing gear, wing struts, or even the propeller blades, since they're known to be strong enough to drag the airplane through the air. To allow for turns, a person may either pick up or push down on the tail to raise either the nose wheel or tail wheel off the ground, then rotate the airplane by hand. A less cumbersome method involves attaching a short tow bar to either the nose wheel or tail wheel, which provides a solid handhold and leverage to steer with, as well as eliminates the danger of handling the propeller. These tow bars are usually a lightweight aluminum alloy construction which allows them to be carried on board the airplane. Other small tow bars have a powered wheel to help move the airplane, with power sources as diverse as lawnmower engines or battery-operated electric drills. However, powered tow bars are usually too large and heavy to be practically carried on small airplanes.

Tractors and towbars

Photo shows a pushback tug carrying a towbar on apron.
A conventional tractor hooked up to a United Airlines Boeing 777-200ER at Denver International Airport

Large aircraft cannot be moved by hand and must have a tractor or tug. Pushback tractors use a low profile design to fit under the aircraft nose. For sufficient traction, the tractor must be heavy, and most models can have extra ballast added. A typical tractor for large aircraft weighs up to and has a drawbar pull of 334 kN (75,000 lbf).[1] Often, the driver's cabin can be raised for increased visibility when reversing, and lowered to fit under aircraft. There are two types of pushback tractors: conventional and towbarless (TBL).

Conventional tugs use a tow bar to connect the tug to the nose landing gear of the aircraft. The tow bar is fixed laterally at the nose landing gear, but allowed to move slightly vertically for height adjustment. At the end that attaches to the tug, the tow bar may pivot freely laterally and vertically. In this manner the tow bar acts as a large lever to rotate the nose landing gear. Each aircraft type has a unique tow fitting, so the towbar also acts as an adapter between the standard-sized tow pin on the tug and the type-specific fitting on the aircraft's landing gear. The tow bar must be long enough to place the tug far away enough to avoid hitting the aircraft, as well as to provide sufficient leverage to facilitate turns. On heavy tow bars for large aircraft, the towbar rides on its own wheels. The wheels are attached to a hydraulic jacking mechanism which can lift the towbar to the correct height to mate to both the airplane and the tug, and once this is accomplished the same mechanism is used in reverse to raise the tow bar wheels from the ground during the pushback process. The tow bar can be connected at the front or the rear of the tractor, depending on whether the aircraft will be pushed or pulled. The towbar has a shear pin. The shear pin prevents the aircraft from being mishandled by the tug—when overstressed the shear pin will snap, disconnecting the bar from the nose gear to prevent damage to the aircraft and tug.

A towbarless tug at Frankfurt Airport transporting a Lufthansa Airbus A340-300
Towbars are used to connect the tractor to the aircraft.

Towbarless tractors do not use a towbar. They scoop up the nose wheel and lift it off the ground, allowing the tug to maneuver the aircraft. This allows better control of the aircraft and higher speeds without anyone in the cockpit.[2] The main advantage of a towbarless tug is simplicity. By eliminating the towbar, operators are alleviated from maintaining many towbars. Also, the physical action and coordination required by the tug operator to move an aircraft with a TBL tug is simpler and easier to learn than with a towbar. By connecting the tug directly to the aircraft's landing gear - instead of through a towbar - tug operators have better control and responsiveness when maneuvering. This is most advantageous in general aviation settings, where operators are often required to move more aircraft (and a wider variety of aircraft) into smaller, more confined spaces than their airline counterparts.

Manufacturers of electric TBL tugs offer a line of models capable of moving any aircraft from the smallest single engine to narrow-body airliners, military cargo and airline-sized business jets. Just as specialized towbars are required for a wide range of aircraft, many TBL tugs use adapters which enable the movement of many unique aircraft. The majority of aircraft do not require adapters, and can be moved without any special adjustments to the tug. This is in contrast to conventional tugs, which often use so-called "universal" towbars that need to be adjusted for many aircraft types. Electric TBL tugs are gaining popularity among general aviation operators and FBOs as an alternative to gas-/diesel-powered, conventional tugs. Being electric- as opposed to internal combustion-powered, electric tugs are low-emission, a major advantage for environmentally-conscious operators. Also, this enables the tug to be safely operated inside a closed hangar.

Robotic tractor

The Lahav Division of Israel Aerospace Industries has developed a semi-robotic towbarless tractor it calls Taxibot that can tow an aircraft from the terminal gate to the take-off point (taxi-out phase) and return it to the gate after landing (taxi-in phase). The Taxibot eliminates the use of airplane engines during taxi-in and until immediately prior to take-off during taxi-out potentially saving airlines billions of dollars in fuel that is used. The Taxibot is controlled by the pilot from the cockpit using the regular pilot controls.[3]

Other equipment applications

While the vehicle is referred to as a pushback tug, it is also used to tow aircraft in areas where taxiing the aircraft is not practical or unsafe, such as moving aircraft in and out of maintenance hangars, or moving aircraft that are not under their own power.

Some airlines, notably Virgin Atlantic, advocated towing aircraft to the holding point of the runway to save fuel and reduce environmental impact,[4] however, the practice was discontinued after landing gear maintenance costs increased due to the stresses originating during the towing process.[5]

Some fuel must still be burned to operate the auxiliary power unit to provide electrical and pneumatic power to run lighting, environmental and communications systems, unless the tug itself provides these sources of power, which some do. This method also places a larger workload on ground crews and equipment, especially if the aircraft and tow tractor ends up having to wait in a long line of aircraft.


Incidents or accidents involving a pushback include:

In the media

In an advertising campaign, also documented on the television show Fifth Gear, a Volkswagen Touareg was used to pull a Boeing 747. As cited before, the "tractor" needs to be heavy to aid traction. The Touareg carried 4.3 tons worth of cement bags, and the tires were inflated to twice the normal pressure to handle the extra weight. Tractor tires have high sidewall ratios for this reason.[6] This is the world record for the heaviest load towed by a production car.


See also


  1. ^
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.

Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.