This article will be permanently flagged as inappropriate and made unaccessible to everyone. Are you certain this article is inappropriate? Excessive Violence Sexual Content Political / Social
Email Address:
Article Id: WHEBN0000032323 Reproduction Date:
The urea breath test is a rapid diagnostic procedure used to identify infections by Helicobacter pylori, a spiral bacterium implicated in gastritis, gastric ulcer, and peptic ulcer disease. It is based upon the ability of H. pylori to convert urea to ammonia and carbon dioxide. Urea breath tests are recommended in leading society guidelines as a preferred non-invasive choice for detecting H. pylori before and after treatment.[1][2]
Patients swallow urea labelled with an uncommon isotope, either radioactive carbon-14 or non-radioactive carbon-13. In the subsequent 10–30 minutes, the detection of isotope-labelled carbon dioxide in exhaled breath indicates that the urea was split; this indicates that urease (the enzyme that H. pylori uses to metabolize urea) is present in the stomach, and hence that H. pylori bacteria are present.
For the two different forms of urea, different instrumentation is required. Carbon-14 is normally measured by scintillation; whereas, carbon-13 can be detected by isotope ratio mass spectrometry or by mass correlation spectrometry. For each of these methods, a baseline breath sample is required before taking the isotope-labeled urea, for comparison with the post-urea sample, with a 20 to 30-minute duration between them. Samples may be sent to a reference laboratory for analysis. Alternatively, mass correlation spectrometry can be performed as an office-based test since breath samples are continuously collected, and results are provided immediately within minutes.[3][4]
The difference between the pre and post urea measurements is used to determine infection. This value is compared to a cut-off value. Results below the value are assumed to be negative, those above positive. The cut-off value itself is determined by comparing the results of patients with two or more different detection methods. The value is chosen that gives the best combination of sensitivity and specificity.
The test measures active H. pylori infection. If antibiotics are depressing the amount of H. pylori present, or the stomach conditions are less acidic than normal, the amount of urease present will be lessened.
Accordingly the test should only be performed 14 days after stopping acid reducing medication (proton pump inhibitors, PPI) or 28 days after stopping antibiotic treatment. Some clinicians believe that a reservoir of H. pylori in dental plaque can affect the result.[5]
: DIG
anat (, , )///
//, /
, drug (////////),
Magnetic resonance imaging, Positron emission tomography, Projectional radiography, Tomography, Neuroimaging
Image, YouTube, Esophagogastroduodenoscopy, Respiratory tract, Bronchoscopy
Protein, Glucose, Glycolysis, Citric acid cycle, Ribose
Medicine, Disease, Physical examination, Symptom, Logic
Skin, Blood, Blood alcohol, Urine, Carbon dioxide
Helicobacter pylori, Stomach, Antibiotics, Aspirin, Duodenum
Carbon, Nitrogen, Neutron, New Zealand, Austria
Medical imaging, Endoscopy, Surgery, Nervous system, Digestion
Medical imaging, Endoscopy, Gallbladder, Medical Subject Headings, Urinary bladder